From its composite fuselage and wings to the revolutionary way that some critical systems are electrically powered, The Boeing Co. has pushed the technology envelope with its 787 Dreamliner.
Among those advances is the first fuel-inerting system designed specifically for an all-new commercial jetliner.
The inerting system that will be used on the 787 works pretty much the same way as one that is being tested on two 747-400s and two 737-700s that are in service with airlines and cargo operators. Boeing won't identify those operators, but does say the four planes have about 10,000 hours of flight time with the inerting system in operation.
Starting next year, Boeing will install the system on all its factory-built 737s, 747s and 777s.
It works by taking some of the air generated by the engines and diverting it through a filter, which separates out nitrogen. The nitrogen is then pumped into the center wing tank as the fuel is used, rendering any fuel vapors inert, because the level of oxygen is too low to support a fire or explosion.
That system had to be modified for the 787, which will be the first commercial jetliner that does not use bleed air from the engines. On today's jets, bleed air is carried by a network of ducts through the plane, and some is used to pneumatically power certain systems. Air-driven pumps, for example, are used to raise the landing gear.
Eliminating bleed air from the engines and powering systems electrically on the 787 will make the Dreamliner more efficient, according to Boeing. But that meant engineers had to find a different way of getting a supply of air to produce nitrogen for the 787 fuel-inerting system.
Air will be drawn from inside the 787 under the cargo floor using a long tube with tiny holes in it that will run the length of the cargo bay. That air then goes into a compressor and an air-separation module that produces the nitrogen. The nitrogen is distributed through ducts to the 787 fuel tanks in the wings and the center wing fuel tank in the fuselage.
And that's another important difference in the 787 fuel-inerting system. All the wing tanks will receive the nitrogen gas, not just the center wing tank. The system that is under evaluation on the four Boeing jets in service, as well as the one that will be on Boeing production jets starting next year, is only on the center wing tank - the tank that exploded on TWA Flight 800.
The Federal Aviation Administration's final rule, which comes out later this year, is expected to require the industry to reduce the flammability of only center wing tanks.
Mike Sinnett, head of 787 systems, said Boeing decided it would be best to have a fuel-inerting system on all of the tanks on the 787.
"In the beginning, we did not have the analysis that we needed to demonstrate that we had to inert the wing tanks," he said. "We thought it would be a good thing to do, and the analysis now is bearing out that decision."
The 787 will be the first large commercial jetliner with a composite wing and fuselage. The thermal characteristics of a composite wing are different from a traditional airplane wing made of aluminum. Aluminum conducts heat much better than composites. What that means on the 787, Sinnett explained, is that it will take longer for the composite wing to heat up. But it also will take longer for the wing to cool down. So any fuel vapors in the 787 wing tanks would be potentially flammable for a slightly longer time than if the wing were made of aluminum.
The inerting system that will be used on the 787 works pretty much the same way as one that is being tested on two 747-400s and two 737-700s that are in service with airlines and cargo operators.
More than 1o years after the TWA Flight 800 crash, the NTSB says that fuel tanks are just as flammable.
Nearly nine years after a fuel tank explosion caused the fatal crash of TWA Flight 800, safety officials say little has been done to reduce the flammability of vapors in aircraft fuel tanks.